Skip to content
Safee Documentation

5-7-2

Release 5.7.2

  1. Message Report Enhancement

The report is now equipped with the multi-vehicle filter at its input. Now you can choose to generate the report for more than one vehicle at once. Not only for a site or category, you can also generate the report for multiple vehicles belonging to multiple levels.

The report output will be divided into 2 tabs.

  1. The first tab is the data table tab. It shows the detailed information about the vehicle(s) at each received message.
  2. The second tab shows the overall information about the selected vehicles, starting from the vehicles level, to the total working time of the vehicles, the total stop time, and finally the number of stops done by the vehicle in the selected time range.

We also added more CAN Bus parameters to the input filter to be shown at the report output if they are already available from the sending device.

Note 1: if you choose to generate the report for more than one vehicle, you can only filter on 24 hours.

Note 2: the report can’t be generated for more than 300 vehicles at a time. The output will list the data for the vehicles sequentially; i.e., the data for the first vehicle will be at the table beginning, then the data of the second vehicle, and so on.

  1. Vehicle Trip Report Enhancement

The report can show now the temperature values for each sensor defined under the company. In addition, you have now the ability to filter on a weekly basis. Moreover, the report output is turned into grid view for more generic tracking.

  1. Fuel distribution Module Enhancement

We added an additional condition to the fuel distribution module configuration. Now you can restrict recording the offloading operations against specific speed threshold. That is, if this feature is enabled and the vehicle is moving with a speed higher than the set threshold and mistakenly, the device send an offload operation start, the system will ignore this operation.